How Can We Help?
How to check ONT service operation mode
DASAN OLTS
Use below command to check ONT mode:
OLT16p(config-gpon-olt[1])# show onu service-mode 13
----------------------------------------------------------------------------
OLT | ONU | STATUS | Serial No. | Service Mode | Service Oper
----------------------------------------------------------------------------
1 | 13 | Active| HALN08604678 | None | SFU
As You can see, ONT is working in SFU mode.
Note: Do not use #onu service-mode ONU_ID SFU/HGU command to change mode.
NOKIA ISAM 7360
Use below command to check ONT mode:
typ:admin># show equipment ont interface 1/1/1/2/33 detail
==========================================================================================================
interface table (detailed)
==========================================================================================================
----------------------------------------------------------------------------------------------------------
interface
----------------------------------------------------------------------------------------------------------
ont-idx : 1/1/1/2/33 eqpt-ver-num : HL-4G_001 sw-ver-act : V2.0.13
sw-ver-psv : V2.0.13 vendor-id : HW equip-id : HL-4G
actual-num-slots : 3 version-number : HL-4G_001 num-tconts : 16
num-trf-sched : 16 num-prio-queues : 160 auto-sw-planned-ver :
auto-sw-download-ver : sernum : HALN:206EB8D8 yp-serial-no : unknown
oper-spec-ver : ctc-v2.0 act-ont-type : hgu act-txpower-ctrl : not-supported
sn-bundle-status : idle cfgfile1-ver-act : cfgfile1-ver-psv :
cfgfile2-ver-act : cfgfile2-ver-psv : actual-us-rate : 1.25g
==========================================================================================================As You can see (act-ont-type : hgu), ONT is working in HGU mode.
