3. XML File configuration

Document Date and version	2021.08.19
Revision	2

Let us know how to improve below document on: support@halny.com

Bridge WAN interface

1. Enable the interface
2. Mode: BRIDGE
3. Service Description: OTHER
4. Bind LAN and WLAN to interface
5. 802.1q: Tag, Set VLAN-ID and 802.1p value
6. IP Version: IPv4
7. Connection type: BRIDGE
8. Default Route: NO

Router WAN interface – static IP

1. Enable the interface
2. Mode: ROUTER
3. Service Description: OTHER
4. Bind LAN and WLAN to interface
5. 802.1q: Tag, Set VLAN-ID and 802.1p value
6. IP Version: IPv4
7. Connection type: STATIC
8. Default Route: YES|NO
9. Configure an IP address for the interface
10. NAT Enable: YES|NO

Router WAN interface – DHCP

1. Enable the interface
2. Mode: ROUTER
3. Service Description: INTERNET
4. Bind LAN and WLAN to interface
5. 802.1q: Tag, Set VLAN-ID and 802.1p value
6. IP Version: IPv4
7. Connection type: DHCP
8. Default Route: YES|NO
9. NAT Enable: YES|NO

Router WAN interface – PPPoE

1. Enable the interface
2. Mode: ROUTER
3. Service Description: INTERNET
4. Bind LAN and WLAN to interface
5. 802.1q: Tag, Set VLAN-ID and 802.1p value
6. IP Version: IPv4
7. Connection type: PPPoE
8. Default Route: YES|NO
9. Set PPPoE username and password
10. NAT Enable: YES|NO

Remote management via Wan ipaddress

1. Enable the interface
2. Mode: ROUTER
3. Service Description: INTERNET
4. Bind LAN and WLAN to interface
5. 802.1q: Tag, Set VLAN-ID and 802.1p value
6. IP Version: IPv4
7. Connection type: PPPoE || STATIC IP || DHCP
8. Default Route: YES
9. NAT Enable: YES

Then go to the Management section and

10. Enable remote web management
11. Set port which is higher then 4000

WLAN SSID and PASSWORD

As default in section SSID and PASSWORD of xml file has written XXXXXX and YYYYYY in accordance.
After applying XML file those X-es and Y-es are swapped to last 6 signs of ONT MAC address.

You can set SSID and PASSWORD manually i.e. :
SSID: UNIVERSE_SSID
PASSWORD: VerySecretPass

Or You can partially generate SSID and PASSWORD:
GPON SN: HALN20123456
SSID-PATTERN: {PREFIX}XXXXXX{POSTFIX}
SSID-REAL: ISP-NAME-654321-2.4G
GPON SN: HALN20123456
PASSWORD-PATTERN: {PREFIX}YYYYYY{POSTFIX}
PASSWORD-REAL: AnyPassword432102AnyPassword

VoIP configuration

1. Assign interface number for VoIP: WAN_ID
2. SIP Proxy Server IP
3. SIP Outbound Proxy Server IP
4. SIP Registrar Server IP
5. Configure VOIP accounts

Rate Limit configuration

Rate-limit is set per CoS value. Before setting rate-limit value, 802.1p bit has to be set correctly, from range 0-7. For example:
WAN1 – Internet CoS ->0
WAN2 – IPTV CoS ->4
WAN3 – VoIP CoS ->6

Rate-limit 150/150 Mbit/s settings for Internet WAN0 with CoS=0:

1. Enable Rate Limit
2. Type set type to “1”
3. Set passthrough to appropriate CoS value

---