How Can We Help?
Switch-mode slider
Document Date and version | 2022.05.23 |
Tested with ONT HALNy HL-4GXV-F | V3.1.21 or above |
Revision | 1 |
Let us know how to improve below document on: support@halny.com |
Concept
![](https://halny.com/wp-content/uploads/2022/05/Switch-mode-slider-ont-1-1024x225.png)
This function allows to change the operating mode in the HALNY ONT equipped with the switch-mode button without manual configuration or XML file.
Modes of the switch-mode button
In the default software the ONT has 5 states:
0 – Switch-mode is disabled.
1 – The device works as an ONT with the GPON’s serial number prefix “HALN”.
2 – Ethernet router function.
3 – The device works as EasyMesh Agent.
4 – Disable all LEDs except ‘POWER’ LED.
Changing the config with switch-mode slider
To switch the operation mode of the ONT, simply use the switch-mode slider by following these steps:
- Assure that the switch-mode slider is enabled. It can be checked on the web page.
- Hold the WPS button.
- Choose the operation mode using slider. After choosing mode 4, the ONT will only disable LEDs.
- Release the WPS button.
- ONT will reboot and start with the selected config.
After restore to defaults the applied slider config will back to config assigned to position 0.
Web management
![](https://halny.com/wp-content/uploads/2022/05/switch_mode_button.png)
The web page allows to check the current and applied slider position.
Enable/Disable Switch functionality
The switch-mode slider functionality can be enabled or disabled using the radio button. To disable it, select “No“.
TR-069
InternetGatewayDevice.DeviceConfig
InternetGatewayDevice.DeviceConfig.X_HALNY_AppliedSliderPossition 1
InternetGatewayDevice.DeviceConfig.X_HALNY_CurrentSliderPossition 1
InternetGatewayDevice.DeviceConfig.X_HALNY_SliderButtonEnable true
The TR-069 allows to check the current and applied slider position. Also, switch-mode slider functionality can be disabled or enabled.
To disable the switch-mode slider via TR-069, the value of parameter ‘X_HALNY_SliderButtonEnable’ must be set to “false” and the configuration committed.
XML Provisioning
To enable/disable the switch-mode slider via an XML file, the ‘ENABLE_SLIDER_BUTTON’ node needs to be used with value ‘YES’ or ‘NO’
![](https://halny.com/wp-content/uploads/2023/03/image.png)
![](https://halny.com/wp-content/uploads/2018/09/Logotyp_Halny_-1024x378.jpg)